Console covers, outboard and inboard engine covers, cockpit enclosures, sail covers and fender covers for marine distributors, boat builders and private-label programmes.
The equipment around the boat usually needs covering before the hull does. Eight directions are in current production, and the deciding factor is normally whether the cover stays on while the boat is being used or only in storage.
Silver-coated Oxford covers that sit over the helm and instruments during short-term storage and mooring.
Shaped covers for outboard cowlings, cut to the engine so the cover follows the shape of the cowling.
Heavier covers for engine boxes and mooring protection where the boat stays in the water.
Canvas enclosures that close the cockpit against wind and rain, patterned to the frame layout.
Full covers in marine-grade fabric, fitted taut over the hull rather than tied loosely.
Small fit-and-forget covers for the wheel and helm, produced in the same fabrics as the larger covers.
Covers for mainsails, jibs and booms, cut to the folded sail dimensions you supply.
Fabric fenders that reduce noise against the hull, produced in SBR and towelling constructions.
Fabrics in current production include silver-coated Oxford, solution-dyed and marine-grade canvas, and SBR laminates. UV resistance and fabric grade are confirmed per project.
Currently in production: console, engine and sail covers we currently produce. If your range also covers the load area, see boat covers.
Cutting, stitching, reinforcement and hardware fitting are carried out on our own line, so covers are patterned to the equipment you are supplying.
Console, cowling or sail dimensions set the outline before cutting starts.
Panels are cut to the confirmed pattern so the cover sits tight rather than loose.
Stress points, tie-downs and zipper areas are reinforced before assembly.
Covers are folded and packed for bulk shipment or retail packaging.
Covers can carry printed branding, size and care labels and retail packaging under your own brand. Screen printing is done in-house, so artwork changes stay within the same project.
Customer artwork, logos and repeat prints are applied on our own screen printing line.
A selection of the brands, distributors and trade customers we manufacture for.
The equipment dimensions matter more than the boat as a whole.
Console, outboard cowling, inboard engine, sail, boom, helm or fender.
The part dimensions, or a photo from two angles if measuring is awkward.
Whether the cover stays on during use or only in storage, which sets the fabric and how it is fixed.
Fabric grade and fastening are agreed per project; covers that stay on during use are specified differently from storage covers.
Yes. Two clear photos plus a dimension or two are normally enough to pattern a console, engine or helm cover.
Coated Oxford and marine canvas are the usual choices. The specific grade is confirmed per project against how the cover will be used.
Enclosures are patterned to the frame layout you supply; window panels and openings are part of the specification rather than a fixed format.
Yes. Printed branding, size and care labels and your own retail packaging are all part of the quotation.
Sampling is part of the normal project flow and the cover is approved before production is scheduled.
Use the form below listing the equipment and dimensions, and we will come back with a proposal.
Measure the console from the deck line up to the top of the screen, and take the width at the widest point. For outboards, note the cowling shape and tiller or control positions. These outlines decide how the cover wraps.
Marine covers face constant sun, salt and damp, so fabric choice matters more than on land. A marine-grade direction resists UV fading and stays flexible in the cold. Tell us the conditions your equipment meets.
A cover may need to protect a whole cockpit, individual fenders or pieces of sailing gear such as a sail or boom. Each item needs its own outline and fastening. Describe what has to be covered and we will plan each piece.
Tell us which parts need covering and how they are used. We reply to every project enquiry.